Setting The Baud Rate (Ddl Mode) - Aventics DDL Mode D'emploi

64 AVENTICS | DDL | R412009417–BDL–001–AD
Commissioning and Operation
B
A
ON
All of these settings are made using the switches beneath the
fittings A and B.
Proceed as follows for all of the presettings:
1. Remove the corresponding fittings.
2. Adjust the corresponding setting as described below.
3. Screw the fittings back in (0.6 + 0.2 Nm). Pay attention that
the sealing rings are positioned correctly.
7.1.1
All participants in a DDL line must be set to the same baud
rate.
Changes during operation
Changes to the DDL mode are only taken over after a voltage
reset.
Never change the settings during operation.
O
Turn the device off before changing the address setting.
O
Set the baud rate under fitting A with the S6 switch, bit 1.
O
Bit1
Table 7:
S6
Baud rate
125 kBaud
OFF
250 kBaud

Setting the baud rate (DDL mode)

NOTICE
Selecting the DDL baud rate with the S6 switch, bit 1
Bit 1
Off
On (presetting)