Lenze 8200 vector Instructions De Montage page 142

7 Commissioning
Parameter setting with the XT EMZ9371BC keypad
V/f characteristic control
Switch−on sequence
8. Set the minimum output frequency (C0010)
Lenze setting: 0.00 Hz
9. Set the maximum output frequency (C0011)
Lenze setting: 50.00 Hz
10. Set the acceleration time T
Lenze setting: 5.00 s
11. Set the deceleration time T
Lenze setting: 5.00 s
12. Set the V/f−rated frequency (C0015)
Lenze setting: 50.00 Hz
13. Set the V boost (C0016)
min
Lenze setting: depends on the controller type
14. Activate the motor temperature monitoring (C0119) if you
have connected a PTC or thermal contact to terminal X2.2
Lenze setting: switched off
When all settings are complete:
15. Select setpoint
16. Enable the controller
17. The drive is now running.
142
(C0012)
ir
(C0013)
if
l
Comment
The Lenze setting is suitable for all common
applications
(¶ 153)
Possible settings
E.g. via potentiometer at terminals 7, 8, 9
Terminal X3/28 = HIGH
If the drive does not start, additionally press u
EDK82EV113 DE/EN/FR 11.0