Lenze 8200 vector Instructions De Montage page 144

7 Commissioning
Parameter setting with the XT EMZ9371BC keypad
Vector control
Switch−on sequence
12. Activate the operating mode "vector control" (C0014 = 4)
Lenze setting: Linear V/f characteristic control (C0014 = 2)
13. Enter the motor data
A Rated motor speed (C0087)
Lenze setting: 1390 rpm
B Rated motor current (C0088)
Lenze setting: depending on the controller
C Rated motor frequency (C0089)
Lenze setting: 50 Hz
D Rated motor voltage (C0090)
Lenze setting: depending on the controller
E Motor cosj (C0091)
Lenze setting: depending on the controller
14. Start the motor parameter identification (C0148)
A Ensure that the controller is inhibited
B Set C0148 = 1
C Enable the controller
If segment c becomes active again after approx. 30 s,
D
inhibit controller again.
15. Activate the motor temperature monitoring (C0119) if you
have connected a PTC or thermal contact to terminal X2.2
Lenze setting: switched off
When all settings are complete:
16. Select setpoint
17. Enable the controller
18. The drive is now running.
144
Comment
See motor nameplate
Enter the value for the motor circuit
configuration (star/delta) selected!
Enter the value for the motor circuit
configuration (star/delta) selected!
Only when the motor is cold!
Terminal X3/28 = LOW
Press TV
l Terminal X3/28 = HIGH
l The identification starts:
– Segment c is off
– The motor consumes current and makes a
high−pitched" tone.
– The motor does not rotate!
l Terminal X3/28 = LOW
l Identification is completed.
l Calculated and stored:
– V/f rated frequency (C0015)
– Slip compensation (C0021)
– Motor stator inductance (C0092)
l Measured and stored:
– Motor stator resistance (C0084) = Total
resistance of motor cable and motor
Possible settings
E.g. via potentiometer at terminals 7, 8, 9
Terminal X3/28 = HIGH
If the drive does not start, additionally press u
l
(¶ 153)
EDK82EV113 DE/EN/FR 11.0