Checking The Running Of The Command Pedal; Start Up; Stop; Machine Use - Berkel BF+15F Mode D'emploi Et D'entretien

5.3 - Checking the running of the command pedal

When the machine is connected to the supply mains ans after having pressed the
start push button (fig. 5.1.1) press the pedal and check the movement of the plug
in the cylinder. Bring the pedal into the correct central position and make sure that
the piston stops.
Note
When pressing the pedal, with the start push button deactivated, the plug should
not move.

5.4 - Start up

-
Put the differential switch located at the head of the machine in "I".
-
Press the start push button "3" (fig. 5.1.1).
-
Press the pedal "4".

5.5 - Stop

-
Press the stop push button "3".
-
Put the differential switch in "0".
6

Machine use

6.1 - Prescriptions

Only authorized personnel can intervene on the machine.
Before starting to use the machine the operator must make sure that all the protec-
tions are in place and that the safety devices are present and efficient. If that is not
the case turn off the machine and contact the person in charge of maintenance.
Carry out some unloaded maneuvers assisted by specialized personnel to acquire
the experience needed to work in safety.
6.2 - Machine use
ATTENTION!
17
Fig. 6.2.1