General Information; Identification Label - battioni Pagani GARDA EVO Serie Notice D'emploi Et D'entretien

instruction manual
for use and maintenance of the combined groups for the GARDA EVO series
The GARDA EVO Group is composed of a gearbox, an application of a centrifuge pump or high pressure pump
and a rotary blades vacuum pump or of splined or keyed shafts. Through one or two selectors, it is possible to use,
at separate times, the rotary blades vacuum pump and a centrifuge pump/high pressure pump.
The two selectors allow the use in combination of the rotary blades vacuum pump and the centrifuge pump/high
pressure pump / splined or keyed shafts.
The GARDA EVO group can be fitted, at the top, with a hydraulic pump for control of the hydraulic mechanisms
(KP 30.27 SAE "B" 2-4 holes) always driven.
STANDARD VERSIONS
- PTO 1000 Rpm
1 - VERSIONS OF THE COMBINED GROUP
CCW as standard
Version D
Splined shaft
1"3/4 - Z6 ISO 500

1.1 IDENTIFICATION LABEL

Each combined group is supplied with an identification label, indicating:
- combined group model
- serial number
- production year
- max relative pressure
- max vacuum
- max absorbed power
- max r.p.m.
- max rate of flow
- weight
Each identification plate is protected by a special film, to remove after painting.
This film has been introduced to guarantee the tracing of the pump for warranty purposes.
page 76

GENERAL INFORMATION

CCW as standard
Version P
Cylindrical Shaft Ø 40,
length 79 mm
tab UNI 6604
CCW as standard
H Version
129 cc/rev - Pmax 400 bar - In G 1" - Out G 1"
240 cc/rev - Pmax 350 bar - In G 1" - Out G 1"
In version H, it is not possible to install
high pressure pumps of 1500-2300 rpm
IDENTIFICATION PLATE
WITH PROTECTIVE FILM FOR PAINTING
PROTETTIVA PER
VERNICIATURA