General Information - battioni Pagani BLW Série Manuel D'instruction

Supplementary instruction manual
for use in areas at risk of explosion
This manual, drawn up by BATTIONI PAGANI
plying with ATEX Directive 2014/34/EU; and it must be kept with the vacuum/pressure lobe pump until dismantling
and be readily available for a quick consultation by users and/or maintenance technicians when necessary. Before
performing any operation with or on the vacuum/pressure lobe pump, the staff in charge must have carefully read
this manual and the manual for use and maintenance supplied with each pump. If the manual is mislaid, becomes
creased or is no longer completely legible, the customer must request a copy from the authorised dealer or directly
from BATTIONI PAGANI
This manual has been prepared by BATTIONI PAGANI
thorised to carry out the installation, use and repair tasks in safety. BATTIONI PAGANI
additions or improvements to this manual at any time and without prior notice, without this resulting in the document being
considered inadequate or deficient for safety purposes.
This danger symbol in the manual means that important safety-related instructions are provided. Operators
are the first recipients of this information and are responsible for their own compliance and that of other
persons exposed to the risks associated with use.
The requirements indicated next to the symbol shown above, highlighted with a border, refer exclusively to equip-
ment which complies with ATEX Directive 2014/34/EU.
This symbol indicates the rules and information that must be observed in the case of use in areas at risk of explosion.
This manual covers the main topics concerning protection against explosions and is an integral part of the "Instruc-
tions Manual for Use and Maintenance" supplied with each vacuum/pressure lobe pump, which must be read in full
by observing all safety precautions.
- Always operate within the limitations of use of the vacuum/pressure lobe pump.
- Delegate the maintenance to qualified personnel.
- Use original spare parts only.
Attention! The instructions in this manual do not replace, but
summarize the obligations of the existing legislation on safety standards.
The vacuum/pressure lobe pumps (ATEX version) comply with ATEX Directive 2014/34/EU and are de-
signed for installation in an assembly.
Carry out a general check, making sure that all the rules in the manual have been observed, before starting
the vacuum/pressure lobe pump.
New risks arising from installations must be assessed by the manufacturer of the new machine.
pag. 14

1.0 - GENERAL INFORMATION

, is an integral part of vacuum/pressure lobe pumps supply, com-
®
.
®
to provide the necessary information to the technicians who are au-
®
reserves the right to make changes,
®