battioni Pagani GARDA EVO Serie Notice D'emploi Et D'entretien page 101

Instruction manual
for use and maintenance of the combined groups for the GARDA EVO series
HOW TO SELECT THE OUTPUTS
I:Anti-clockwise hydraulic motor (standard).
A:output A (centrifugal pump).
B:output B (AIDA blower).
Figure 1 Garda Evo layout
Figure 2 Output B selected Figure 3 Output A selected
The position of the manual lever described above is also valid with hydraulic and pneumatic rotary cylinder.
INSTALLATION
The Garda Evo group must be installed rigidly on a planar frame (sized to prevent vibrations and buckling) with a MAX
tilt of 3°. Ensure sufficient space for the circulation of cooling air and to reach the lubrication points (oil levels, grease
nipples, etc.). Leave room to manoeuvre the selection levers. Secure to the frame before the most rigid part (Garda Evo
box) and then the blower. If necessary reposition the feet with the relevant spacers. The support of the hydraulic motor
is fitted with a bracket. This must be suitably attached to the frame, avoiding tensions on the bell itself.
page 83