Control Devices - battioni Pagani GARDA EVO Serie Notice D'emploi Et D'entretien

instruction manual
for use and maintenance of the combined groups for the GARDA EVO series
4.3.3 - CENTRIFUGE PUMP
Hydraulic connection diagram of the operation of the
centrifuge is represented in Figure 1 where the entry of
liquid/slurry "B" and the exit of the liquid/slurry "A" are
highlighted.
WARNING: the centrifuge is not self-priming.
Do not use the centrifuge dry, otherwise the
mechanical seal could burn.
Centrifuge
CENTRIFUGE DODA AFI-27
CENTRIFUGE DODA AFI-27 HS
CENTRIFUGE DODA AFI-35
CENTRIFUGE GARDA 6500
Table 1

4.4 CONTROL DEVICES

To operate the rotary blades vacuum pump turn the lever on the gearbox to the right (position "D").
To operate the centrifuge, turn the handle on the gearbox to the left (position "C").
Selection of the position "C" or "D" of the Garda Evo group must be performed when the PTO is not energised. To
control the suction and compression phases of the rotary blades vacuum pump it is possible to use the handle
located on the manifold, adjustable by hand. To select the phases of suction and compression turn the handle in the
directions indicated in the manual of the individual pumps.
C
page 80
Geometric Flow Rate
m /h l/min US gpm
3
210 3500 924.6
132 2200 581
270 4500 1188.8
390 6500 1717
D
"B"
Figure 1
Max rev Max rev
operating operating
speed speed
garda evo centrifuge
cfm
(rpm) (rpm)
123 1000 2300
77 1000 3350
159 1000 2300
229 1000 2400
The suction-compression selection performed with the handle
of the rotary blades vacuum pump must be carried out with the
pump not activated.
Max absolute
Absorption
pressure
Bar PSI kW hp
6.5 94 70 94
14 202 105 141
11 160 130 174
7 101 60 80.4
Weight
(kg)
153
153
165
132