Gearbox Lubrication - battioni Pagani GARDA EVO Serie Notice D'emploi Et D'entretien

instruction manual
for use and maintenance of the combined groups for the GARDA EVO series

GEARBOX LUBRICATION

The toothed wheels in the gearbox are lubricated from splashes. Ensure filling with the correct quantity of oil as
specified above.
• First oil change between 100/200 hours and then every 300 hours (see above)
• Check oil level before using the combined group
• Maximum temperature of the oil of 95°C during operation
START/USE/STOP
1. Connect the hydraulic motor to the system
2. Select the desired output lever
3. Output selection (A or B) must be made with the hydraulic motor off.
4. To complete the operations stop the hydraulic motor.
HYDRAULIC MOTOR INSTALLATION
The installed hydraulic motor can work both with open and closed circuit. The hydraulic motor is connected to the
shaft of the gearbox with a flexible coupling which protects the motor from vibrations and misalignments of assembly
(the polymer constituting the joint is subject to wear. Its duration also depends on the relevant environmental
conditions of use).
page 84
oil top-up
Figure 4 Oil top-up/inspection (sheet parameters above)
2nd oil top-up/
dipstick