battioni Pagani GARDA EVO Serie Notice D'emploi Et D'entretien page 117

Instruction manual
for use and maintenance of the combined groups for the GARDA EVO series
HOW TO SELECT THE OUTPUTS
I:PTO anti-clockwise (standard).
A:output A (centrifugal pump).
B: output B (rotary blades vacuum pump).
Figure 1 Garda Evo layout
Figure 2 Output A selected Figure 3 Output B selected
The position of the manual lever described above is also valid with hydraulic and pneumatic rotary cylinder.
INSTALLATION
The Garda Evo group must be installed rigidly on a planar frame (sized to prevent vibrations and buckling) with a MAX
tilt of 3°. Ensure sufficient space for the circulation of cooling air and to reach the lubrication points (oil levels, grease
nipples, etc.). Leave room to manoeuvre the selection levers. Secure to the frame before the most rigid part (Garda Evo
box) and then, if necessary, reposition the feet of the vacuum pump with the relevant spacers.
page 99