Selecting The User - Beurer BC 87 Mode D'emploi

Display Interpretation
Position indicator You have not yet reached the recom-
is coloured red mended position of the measuring
. device at heart level – your wrist is
D
either positioned too high or too low.
Position indicator You have reached the recommended
is coloured green; position of the measuring device at
the word "OK" heart level and can start the measure-
also appears . ment by pressing the START/STOP
E
button
In the vast majority of use cases, the position indicator pro-
vides an excellent guide as to whether the measuring device
is at heart level. Due to physical differences such as size and/
or physique on the user side, this function may not be helpful
in all cases. If you feel that the wrist position according to the
position indicator does not match the level of the heart, use
your own judgement. You can also start the measurement in
these cases at any time by pressing the START/STOP but-
ton .

Selecting the user

This device has 2 user memories with 120 memory spaces
each in order that you can save measurements from 2 differ-
ent people separately from each other.
If multiple people are using the device, make sure that the
relevant user is set before each measurement.
Please refer to the section "Adjusting the settings" for infor-
mation on how to select the desired user.
.
Performing the blood pressure measurement
Measurement
Press the START/STOP button
monitor. All display elements are briefly displayed.
• The blood pressure monitor will begin the measurement
automatically after approx. 3 seconds.
• The cuff inflates automatically while the actual measure-
ment process starts. As soon as a pulse is found, the
pulse symbol is displayed.
You can cancel the measurement at any time by
pressing the START/STOP button
• The remaining air is released quickly once the measure-
ment is complete.
• Systolic pressure, diastolic pressure and pulse measure-
ments are displayed. A symbol in the display also ap-
pears which shows you whether you were sufficiently
relaxed during the blood pressure measurement or not
( symbol = sufficiently at rest;
rest). Observe the chapter on evaluating results/resting
indicator measurement in these instructions for use.
• Press the START/STOP button
pressure monitor. The measurement is then stored in the
selected user memory.
• appears if the measurement could not be performed
properly. In this case, please read the section "What if
there are problems?".
30
to start the blood pressure
.
symbol = not at
to switch off the blood