Initial Use; Inserting The Batteries; Adjusting The Settings - Beurer BC 87 Mode D'emploi

Information on the display:
The corresponding drawings are shown on page 3.
Time and date
1
Battery indicator
2
Symbol for Bluetooth
3
transfer
Resting indicator display
4
5 User memory /
Number of memory spaces / memory display for aver-
6
age value ( ), morning (

6. INITIAL USE

Inserting the batteries

• Remove the battery compartment lid on the left side of
the device .
A
• Insert two 1.5 V AAA micro (alkaline type LR03) batteries.
Make sure that the batteries are inserted the correct way
round in accordance with the markings
rechargeable batteries.
• Close the battery compartment lid again carefully.
• flashes on the display. Now set the date and time as
described below.
Calculated pulse rate
7
Symbol for irregular
8
heartbeat
®
Symbol for pulse
Risk indicator
9
Diastolic pressure
10
Systolic pressure
11
), evening ( )
. Do not use
A
If the battery change symbol
appears, no further measurements are possible and you must
replace all batteries. Once the batteries have been removed
from the device, the date and time must be set again. Any
saved measured values are retained.

Adjusting the settings

You must make sure that the device has the correct settings
before use in order to be able to make full use of all functions.
Only by doing so can your measurements with associated
date and time be saved and accessed later by you.
There are two different ways to access the menu from
which you can adjust the settings:
• Before initial use and after each time you replace the
battery:
When inserting batteries into the device, you will be taken
to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off press and hold the START/
STOP button for approx. 5 seconds.
In this menu you can adjust the following settings in succes-
sion:
Hour
Date
format
27
is flashing and
Time User