Beurer BC 87 Mode D'emploi page 34

This enables it to indicate whether the blood pressure was
taken when the user's circulatory system was sufficiently at
rest.
The measured blood pressure value was ob-
tained when the user's circulatory system was
sufficiently at rest and reliably corresponds to the
blood pressure at rest.
Indicates that the value was obtained when the
user's circulatory system was not sufficiently
at rest. The blood pressure values measured
in this case generally do not correspond to the
blood pressure at rest. The measurement should
therefore be repeated after a period of physical
and mental rest lasting at least 5 minutes.
No During the measurement it was not possible to
resting determine whether the user's circulatory system
indicator was sufficiently at rest. In this case too, the
symbol measurement should be repeated after a period
is dis- of rest lasting at least 5 minutes.
played
If the user's circulatory system was not sufficiently at rest, this
can be caused by various factors such as physical or mental
strain or distraction, speaking, or experiencing irregular heart-
beat during the measurement.
In an overwhelming number of cases, HSD will give a very
good guide as to whether the user's circulatory system is
rested when taking a blood pressure measurement.
However, certain patients suffering from irregular heartbeat or
chronic mental conditions may remain haemodynamically un-
stable even in the long-term, something which persists even
after repeated periods of rest. The accuracy of the results for
the blood pressure at rest is reduced in these users.
Like any medical measurement method, the precision of HSD
is limited and can lead to incorrect results in some cases.
Nevertheless, the blood pressure measurements taken when
the user's circulatory system is sufficiently at rest represent
particularly reliable results.
Saving, accessing and deleting measured
values
User memory
The results of every successful measurement are stored to-
gether with the date and time. The oldest measurement is
overwritten in the event of more than 120 measurements.
• To select the relevant user memory, press the memory
button M1 (for user
the device is switched off. Then confirm your selection by
pressing the START/STOP button
• If Bluetooth ® is activated (the
display), the blood pressure monitor attempts to connect
to the app. The buttons are deactivated and the symbol
ceases to flash as soon as a connection is established
and the data is transferred.
If you press the M1 or M2 memory button during this pro-
cess, the transfer is cancelled. The
shown.
34
) or M2 (for user memory
.
symbol flashes on the
symbol is no longer
) when