Initial Use - Beurer BM 35 Mode D'emploi

6. Initial use

Inserting the batteries
• Remove the battery
cover from the back of
the monitor.
• Insert four AAA 1.5 V
alkaline batteries. Making
absolutely sure that you
insert them with the cor-
rect polarity as marked.
• Replace the battery
cover carefully
If the battery change
urement is no longer possible and you must replace all the bat-
teries. Once batteries have been removed from the device, the
time must be reset.
Making settings
You must make sure that the device has the correct settings
before use in order to be able to make full use of all functions.
Only by doing so can your measurements with associated date
and time be saved and accessed later by you.
There are two different ways to access the menu from
which you can adjust the settings:
• Before initial use and after each time you replace the bat-
tery:
• When inserting batteries into the device, you will be tak-
en to the relevant menu automatically.
• If the batteries have already been inserted:
4 x AAA (LR03) 1,5 V
is continuously illuminated, meas-
• Press and hold the memory button
when
In this menu you can adjust the following settings in succession:
V Date
➔
The month flashes on the display.
• Using the + setting buttons, select your
desired month and confirm with the
memory button.
The day flashes on the display.
• Using the + setting buttons, select your
desired day and confirm with the
ory button.
If the hour format is set as 12h, the day/month dis-
play sequence is reversed.
The hour flashes on the display.
• Using the + setting buttons, select your
desired number for the hour and confirm
with the
The minute flashes on the display.
• Using the + setting buttons, select your
desired number for the minute and confirm
with the
24
for approx. 5 seconds.
Time
memory button.
memory button.
on the device
mem-