English
Full Harness
2
Put on the harness (1) and close the
N
locking plate (3).
Adjust the length of the strap – with
N
the machine attached, the
carabiner (2) must be about a
hand's width below your right hip.
Balance the machine – see
N
"Balancing the Machine".
24
Balancing the Machine
Attaching the unit to the harness
1
3
The type and style of the harness and
carabiner (spring hook) depend on the
market.
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube.
Loosen the screw (3).
N
Balancing the brushcutter
The unit is balanced differently,
depending on the cutting attachment
used.
Proceed as follows until the conditions
specified under "Floating positions"
have been met:
Adjust the carrying ring.
N
Tighten the screw moderately.
N
Allow the unit to hang freely.
N
Check the position obtained.
N
FS 90, FS 90 R