Adjusting The Throttle Cable - Stihl FS 90 Notice D'emploi

Mounting the Loop Handle without
Barrier Bar
7
7
8
8
4
3
5
6
1
1
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Position the clamp (6) against the
N
drive tube.
Line up the holes.
N
Fit washers (8) on the screws (7)
N
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
Go to "Securing the Loop Handle".
N
FS 90, FS 90 R
Securing the Loop Handle
A
9
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 20 cm (8 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
The sleeve (9) (not fitted on all models)
must be between the loop handle and
the control handle.

Adjusting the Throttle Cable

Some machine versions are equipped
with a throttle cable adjuster on the
control handle.
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
Adjust the throttle cable only after the
4
unit is fully assembled – the control
handle must be in the normal operating
position.
Use a suitable tool to push the slide
N
to the end of the slot (see
illustration).
Press down the throttle trigger
N
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
English
2
1
17