Adjusting The Throttle Cable - Stihl FS 410 C-M Notice D'emploi

Move the handlebar to the required
N
position.
Closing the wing screw
Turn the wing screw clockwise as
N
far as stop.
Fold the grip of the wing screw down
N
so that it is flush.
FS 410 C-M, FS 460 C-M
Swiveling the handlebar
Transport position
2
7
Loosen the wing screw (7) and
N
unscrew it until the handlebar (2)
can be turned clockwise.
Turn the handlebar 90° and then
N
swing the handles down.
Tighten down the wing screw (7)
N
firmly.
Working position
Reverse the sequence described
N
above to swing the handles up and
turn the handlebar
counterclockwise.

Adjusting the Throttle Cable

It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
Set the throttle trigger to the full
N
throttle position.
Carefully rotate the screw in the
N
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
English
15