Inspections And Maintenance By Dealer - Stihl FS 410 C-M Notice D'emploi

Thoroughly clean the clamp area of
N
the handlebar with the cloth and
cleaning solution.
Line up the handlebar and secure it
N
in position with the wing screw.
Handlebar cannot be clamped firmly in
position
Release handlebar in clamp as
N
described under "Handlebar is
difficult to move".
Degrease clamp area on handlebar
N
and in clamp moldings.
Line up the handlebar and secure it
N
in position with the wing screw.
FS 410 C-M, FS 460 C-M
Inspections and Maintenance
by Dealer
Maintenance work
STIHL recommends that maintenance
and repair work be carried out only by
STIHL servicing dealers.
Fuel pickup body in tank
Check the pickup body in the fuel
N
tank annually and replace it when
necessary
The pickup body should rest in the area
of the tank indicated in the drawing.
Spark arresting screen in muffler and
spacer
2
If engine performance deteriorates,
N
have the spark arresting screen (1)
in the muffler checked
Check spacer (2) for damage
N
Have a damaged spacer (2)
N
replaced immediately
Antivibration elements
Four antivibration elements (arrows) for
damping vibrations are installed
between the engine and the drive tube.
Have them checked in the event of
noticeable, constantly increased
vibration.
Both vibration gaps (arrows) of the
antivibration system are set to a fixed
dimension at the factory and are equally
wide. If there is a large difference
English
31