English
Mounting the Deflector
Use the Right Deflector
1
2
WARNING
The deflector (1) is approved for brush
knives only and must therefore be
mounted before fitting a brush knife. It is
also necessary to change the guard
ring ((2), see "Mounting the Cutting
Attachment" / "Mounting Mowing
Attachments".
3
WARNING
Stop (3) is approved for circular saw
blades only and must therefore be
mounted before fitting a circular saw
blade.
16
Mounting the Deflector
Deflectors (1 and 3) are mounted to the
gearbox in the same way.
5
4
Remove dirt from joints on gearbox
N
and deflector – make sure that no
dirt gets into the screw holes in the
gearbox.
Place the deflector on the
N
gearbox (4).
Insert the screws (5) and tighten
N
them down firmly.
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Fitting the Thrust Plate
4
1
2
3
Slip the thrust plate (1) over the
N
shaft (2).
Your power tool comes from the factory
with a guard ring (3) for circular saw
blades.
FS 410 C-M, FS 460 C-M