Assembling The Trimmer; Mounting The Deflector; Mounting The Loop Handle; Adjusting Trimmer For User - Stihl FSA 57 Notice D'emploi

English
7

Assembling the Trimmer

7.1

Mounting the Deflector

► Switch off the trimmer and remove the battery.
1
2
The line limiting blade (1) is already installed in
the deflector (2) and must not be removed.
► Push the deflector (2) into the guides on the
housing as far as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
The deflector (2) must not be removed again.
7.2 Mounting and Removing the
Mowing Head
7.2.1 Mounting the Mowing Head
► Switch off the trimmer and remove the battery.
1
2
► Fit the fanwheel (2) on the shaft (3) with fan
blades facing down.
If the fanwheel is not fitted, the motor will not
be cooled properly and the trimmer will cut out
during operation.
► Hold fanwheel (2) steady with one hand.
► Fit the mowing head (1) on the shaft (3),turn it
counterclockwise by hand and tighten it down
firmly.
32
3
2
1
3
7.2.2 Removing the Mowing Head
► Switch off the trimmer and remove the battery.
► Hold fanwheel (2) steady with one hand.
► Unscrew the mowing head (1) counterclock‐
wise.
► Remove the fanwheel.
7.3

Mounting the Loop Handle

► Switch off the trimmer and remove the battery.
1
► Line up the loop handle (2) so that the recess
for the star knob nut (1) is on the right of the
control handle and the openings in the loop
handle (2) are facing the operator.
► Ease the ends of the loop handle (2) apart and
2
push it onto the control handle until it engages
in position.
► Insert the screw (3) through the hole.
► Fit the star knob nut (1) and tighten it down.
The loop handle (2) must not be removed again.
8

Adjusting Trimmer for User

8.1

Adjusting Length of Shaft

The length of the shaft can be adjusted to suit
the height and reach of the user.
► Switch off the trimmer and remove the battery.
► Hold the shaft firmly.
7 Assembling the Trimmer
1
2
2
3
0458-806-9621-B.VA0.M20.