Assembling The Trimmer; Mounting The Loop Handle - Stihl FSA 130 R Notice D'emploi

English
► Ensure that the following components are in a
safe condition:
– Brushcutter, 4.6.1.
– Deflector, 4.6.2.
– Mowing head,
attachment, 4.6.4.
– Battery as described in the STIHL AR bat‐
tery's instruction manual or in the user
instructions for the "AP belt bag with con‐
necting cable".
► Check the battery as described in the STIHL
AR battery's instruction manual or in the user
instructions for the "AP belt bag with connect‐
ing cable".
► Fully charge battery as described in the User
Manual for the STIHL AL 101, 301, 301-4, 500
chargers.
► Clean the brushcutter,
► Mount the loop handle,
► Select combination of cutting attachment,
deflector and carrying system,
► Mount the deflector,
► If you are using a universal deflector together
with a mowing head: Fit the skirt and line limit‐
ing blade, 6.4.1.
► If you are using a metal cutting attachment:
Mount loop handle with barrier bar,
► Mount mowing head or metal cutting attach‐
ment, 6.5.1 or
► Put on and adjust the STIHL AR battery, carry‐
ing system or "AP belt bag with connecting
cable", 7.
► Balance the brushcutter,
► Adjust the loop handle,
► Check the controls,
► If you cannot carry out this work: Do not use
your brushcutter and contact your STIHL
authorized dealer for assistance.
6

Assembling the Trimmer

6.1

Mounting the Loop Handle

► Switch off the trimmer and pull the connecting
cable plug out of the socket.
32
4.6.3 or metal cutting
15.1.
6.1.
20.
6.3.1.
6.2.
6.6.1.
7.4.
7.5.
10.1.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
drive tube (5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle
(3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
6.2 Mounting Loop Handle with
Barrier Bar
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
1 2
► Insert nuts (2) in the barrier bar (1) so that the
holes line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (4) and
barrier bar (4) on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert and tighten down the screws (8).
6.3 Mounting and Removing the
Deflector
6.3.1 Mounting the Deflector
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
6 Assembling the Trimmer
3
4
5
3 4
5
6
7
8
0458-725-9621-C