Adjusting Nylon Line - Stihl FSA 130 R Notice D'emploi

11 Operating the Trimmer
► Hold the trimmer with the other hand on the
loop handle – wrap your thumb around the
loop handle.
If you are using a metal cutting attachment:
► Hold the trimmer with your right hand on the
control handle – wrap your thumb around the
control handle.
► Hold the trimmer with the other hand on the
loop handle – wrap your thumb around the
loop handle.
11.2 Setting the performance level
Depending on the application, 3 power levels
can be set. The LEDs indicate the selected
power level. The higher the power level, the
faster the cutting attachment can run.
The selected power level affects the battery's
runtime. The lower the power level, the longer
the runtime.
1
► Push the release slide (1) in the direction of
the loop handle with your thumb and hold it
there.
The LEDs indicate the selected power level.
► Push the release slide (1) forwards, hold it
briefly in that position and allow it to spring
back.
This selects the next power level. After the
third performance level, it starts again with the
first performance level.
► Push the release slide (1) forwards and allow
it to spring back as many times as necessary
to select the required power level.
0458-725-9621-C
11.3 Mowing
The cutting height is determined by the distance
of the cutting attachment from the ground.
Mowing with a mowing head (A)
► Swing the brushcutter steadily back and forth
in an arc.
► Move forward slowly in a controlled manner.
Mowing with a grass cutting blade or brush
knife (B)
► Mow with the left-hand side on the metal cut‐
ting attachment.
► Move forward slowly in a controlled manner.
11.4

Adjusting Nylon Line

11.4.1 Line Feed on AutoCut Mowing Head
► Tap the rotating mowing head on the ground.
About 30 mm of fresh nylon line is advanced.
The line limiting blade in the deflector trims the
mowing lines to the correct length.
2 1
Automatic feed does not operate if the mowing
lines are shorter than 25 mm.
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Depress the spool (1) on the mowing head
and hold it depressed.
► Pull out the mowing lines (2).
► If the mowing lines (2) cannot be pulled out to
the required length: Replace the spool (1) or
the mowing lines (2).
The spool is empty.
English
A B
39