Assembling The Trimmer - Stihl FSA 60 R Notice D'emploi

English
6.3 State of Charge
1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.
Malfunction in trimmer or battery.
6.5 LED on Charger
The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7

Assembling the Trimmer

7.1 Mounting the bump guard
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the ends of the bump guard (1) into the
holes (2) in the housing.
The bump guard (1) need not be removed.
32
80-100%
60-80%
40-60%
20-40%
0-20%
2
2
1
7.2 Mounting the guard
► Switch off the brushcutter and remove the bat‐
tery.
1
2
The line limiting blade (1) has already been
installed in the guard (2) and must not be
removed.
► Push the guard (2) into the guides on the
housing until it hits the limit stop.
The guard (2) is flush with the housing.
► Insert and tighten down the screws (3).
The guard (2) must not be removed.
7.3 Mounting the Loop Handle
► Switch off the brushcutter and remove the bat‐
tery.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
7.4 Mounting and Removing the
Mowing Head
7.4.1 AutoCut C 6-2 mowing head
Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
7 Assembling the Trimmer
2
3
4
5
0458-832-9621-D
3