Adjusting Trimmer For User; Adjusting And Setting The Loop Handle - Stihl FSA 60 R Notice D'emploi

8 Adjusting Trimmer for User

1
2
► Position the mowing head (1) on the shaft (2).
► Hold the mowing head (1) with your hand.
► Manually rotate the cap (3) clockwise and
tighten it.
Removing the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Hold the mowing head with your hand.
► Manually rotate the cap counterclockwise until
the mowing head can be removed.
7.4.2 PolyCut 6-2 mowing head
Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
1
2
► Position the mowing head (1) on the shaft (2).
► Hold the mowing head (1) with your hand.
► Manually rotate the upper part (3) clockwise
and tighten it.
Removing the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Hold the mowing head with your hand.
► Manually rotate the upper part counterclock‐
wise until the mowing head can be removed.
7.4.3 DuroCut 5-2 mowing head:
Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
0458-832-9621-D
3
1
3
1
1
2
3
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Position the mowing head (1) on the shaft (3).
► Hold the fanwheel (4) with your hand.
► Manually rotate the mowing head (1) clock‐
wise and tighten it.
Removing the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Hold the fanwheel with your hand.
► Unscrew the mowing head counterclockwise.
► Remove the thrust plate.
8 Adjusting Trimmer for User
8.1 Adjusting and Setting the Loop
Handle
The loop handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter and remove the bat‐
tery.
a
3
► Undo the screws (2).
► Move the loop handle (1) to the required posi‐
tion and check that the following conditions
are met:
– The bump guard (3) fits between the loop
handle (1) and the control handle.
– a = no more than 30 cm.
► Tighten down the screws (2) so that the loop
handle (1) cannot be rotated on the shaft.
English
1
4
1
2
33