Transporting; Storing; Cleaning - Stihl FSA 60 R Notice D'emploi

English
► Clean the trimmer.
► Clean the deflector.
► Clean the cutting attachment.
► Clean the battery.

14 Transporting

14.1 Transporting the brushcutter
► Switch off the brushcutter and remove the bat‐
tery.
Carrying the Brushcutter
► Carry the brushcutter in one hand properly
balanced by the shaft, with the cutting attach‐
ment behind you.
Transporting the brushcutter in the car
► Secure the brushcutter to prevent turnover
and movement.
14.2 Transporting the Battery
► Switch off the trimmer and remove the battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the
battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the
packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the
transport of dangerous goods. The battery is
classified as UN 3480 (lithium-ion batteries) and
has been tested in accordance with UN Manual
of Tests and Criteria, Part III, sub-section 38.3.
For transport regulations see www.stihl.com/
safety-data-sheets
14.3 Transporting the Charger
► Disconnect the plug from the wall outlet.
► Remove the battery.
► Wind up the connecting cable and attach it to
the charger.
► Transporting the charger in a vehicle: Secure
the charger with lashing straps, belts or a net
to prevent it turning over and moving.

15 Storing

15.1 Storing the Trimmer
► Switch off the trimmer and remove the battery.
► Remove the spool.
► Observe the following points when storing the
trimmer:
– The trimmer is out of the reach of children.
– The trimmer is clean and dry.
36
15.2 Storing the Battery
STIHL recommends that you store the battery
with a charge between 40 % and 60 % (2 LEDs
glow green).
► Observe the following points when storing the
battery:
– Battery is out of the reach of children.
– Battery is clean and dry.
– Battery is in an enclosed space.
– Store the battery separately from the trim‐
mer and charger.
– Battery is in non-conductive packaging.
– Battery is in a temperature range between
-10°C and +50°C.
15.3 Storing the Charger
► Disconnect the mains plug from the power
supply.
► Remove the battery.
1
► Wind up the connecting cable and attach it to
the charger.
► Observe the following points when storing the
charger:
– Charger is out of the reach of children.
– The charger is clean and dry.
– Charger is in an enclosed space.
– Charger is stored separately, away from the
battery.
– The charger is not suspended from the con‐
necting cable or the holder (3) for the con‐
necting cable.
– Charger is in a temperature range between
+ 5°C and + 40°C.

16 Cleaning

16.1 Cleaning the Brushcutter
► Switch off the brushcutter and remove the bat‐
tery.
► Clean the brushcutter with a damp cloth.
► Clean vents with a paintbrush.
► Remove foreign objects from the battery com‐
partment and clean the battery compartment
with a damp cloth.
► Clean the electrical contacts in the battery
compartment with a paintbrush or soft brush.
14 Transporting
2
3
0458-832-9621-D