Mounting The Loop Handle; Mounting The Deflector; Mounting The Cutting Attachment - Stihl FS 38 Notice D'emploi

Mounting the Loop Handle

1
5
50 mm
(2")
2
4
A
Fit the loop handle (1) on the drive
N
tube about 15 cm (6") (A) forward of
the control handle (2).
Place the clamp (3) against the
N
drive tube and push it into the loop
handle.
Place the square nut (4) in the loop
N
handle,
insert the screw (5) from the other
N
side and tighten it down firmly.
Adjusting loop handle to most
comfortable position
Loosen the screw (5).
N
Move the loop handle along the
N
drive tube as required.
Tighten down the screw (5) firmly.
N
FS 38

Mounting the Deflector

2
Push the deflector (1) over the
N
clamp (2) as far as stop.
4
3
Insert the nut (3) in the hex recess in
N
the deflector – make sure the holes
line up.
Insert the screw (4) and tighten it
N
down firmly.
Mounting the Cutting
Attachment
Preparations
1
3
N
Lay your trimmer on its back with
the loop handle and shroud pointing
down and the output shaft facing up.
English
11