Stihl FS 38 Notice D'emploi page 15

Masquer les pouces Voir aussi pour FS 38:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STIHL AutoCut C 5-2
8
2
9
Slip the mowing head (2) on to the
N
shaft – as AutoCut 5-2.
Turn the spool (9) clockwise until
N
the two arrow heads line up –
secure the spool in this position.
Insert the cap (8) in the spool, press
N
it down as far as stop and turn it
clockwise at the same time.
Turn the cap until you feel
N
resistance and then tighten it down
firmly by hand.
FS 38
STIHL PolyCut 6-3
10
11
5
Fit the thrust plate on the shaft.
N
Insert the nut (10) in the mowing
N
head.
Screw the mowing head (11)
N
clockwise on to the shaft (5) as far
as stop.
Block the shaft – see "Blocking the
N
Shaft".
Tighten down the mowing head.
N
NOTICE
Remove the locking pin.
Blocking the shaft
To block the shaft, insert a suitable
N
tool (12) through the holes (13) in
the deflector and thrust plate – turn
the thrust plate back and forth if
necessary.
English
13

Publicité

Chapitres

Table des Matières
loading

Table des Matières