Stihl FS 38 Notice D'emploi page 14

Masquer les pouces Voir aussi pour FS 38:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Thrust plate
1
3
2
4
The thrust plate is shipped with the
PolyCut 6-3 and FixCut 5-2. It is only
required for these mowing heads.
STIHL AutoCut 5-2 mowing head,
STIHL AutoCut C 5-2 mowing head
Pull the thrust plate (1), if fitted, off
N
the shaft (2).
STIHL PolyCut 6-3 mowing head,
STIHL FixCut 5-2 mowing head
Slip the thrust plate (1) over the
N
shaft (2) and engage the hex
recess (3) on the external
hexagon (4).
Mounting the Mowing Head
Keep the instruction sheet for the
mowing head in a safe place.
12
STIHL AutoCut 5-2
4
2
1
3
Fit the spring (1) in the mowing
N
head (2).
Wind the mowing line (3) on to the
N
spool (4).
Thread the nylon line through the
N
sleeves and fit the spool in the head.
The individual steps are described in the
instruction sheet supplied.
3
6
Slip the mowing head (2) over the
N
shaft (5) and engage hex recess (7)
on the external hexagon (6).
Fit the cap (8) on the mowing head
N
– screw it clockwise on to the shaft
as far as stop and tighten it down
firmly.
8
2
7
5
FS 38

Publicité

Chapitres

Table des Matières
loading

Table des Matières