Preparing Kombimotor For Operation; Assembling The Kombimotor; Mounting The Loop Handle - Stihl KMA 130 R Mode D'emploi

5 Preparing KombiMotor for Operation

■ Harsh detergents, cleaning with a water jet or
sharp objects can damage the KombiMotor. If
the KombiMotor is not cleaned correctly, com‐
ponents may no longer function properly or
safety devices may be rendered inoperative.
They may cause serious injury to persons.
► Clean the KombiMotor as described in this
instruction manual.
■ If the KombiMotor is not serviced or repaired
correctly, components may no longer function
properly or safety devices may be rendered
inoperative. This may result in serous or fatal
injury to people.
► Do not attempt to service or repair the Kom‐
biMotor.
► If the KombiMotor needs to be serviced or
repaired: Contact your STIHL servicing
dealer for assistance.
5 Preparing KombiMotor for
Operation
5.1 Preparing the KombiEngine for
Operation
The following steps must be performed before
commencing work:
► Ensure that the following components are in a
safe condition:
– KombiEngine,
– Mount the KombiTool as described in the
User Manual supplied with the KombiTool.
– Battery as described in the STIHL AR bat‐
tery's instruction manual or in the user
instructions for the "AP belt bag with con‐
necting cable".
► Check the battery as described in the STIHL
AR battery's instruction manual or in the user
instructions for the "AP belt bag with connect‐
ing cable".
► Fully charge battery as described in the User
Manual for the STIHL AL 101, 300, 301-4, 500
chargers.
► Clean the KombiEngine,
► Mount the loop handle,
► If an FS KombiEngine or RG KombiEngine is
used: Mount the barrier bar,
► Mount the KombiTool as described in the User
Manual supplied with the KombiTool.
► Put on and adjust the STIHL AR battery, carry‐
ing system or "AP belt bag with connecting
cable", 7.
► Adjust the loop handle,
► Check the controls,
0458-805-9621-B
4.6.
15.
6.1.
6.2.
7.4.
10.1.
► If you cannot carry out these steps: Do not use
your KombiEngine and contact your STIHL
dealer for assistance.
6 Assembling the KombiMo‐
tor
6.1

Mounting the Loop Handle

► Switch off the KombiMotor and pull the con‐
necting cable plug out of the socket.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
drive tube (5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle
(3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
The loop handle must not be removed again.
6.2 Mounting Loop Handle with
Barrier Bar
► Switch off the KombiMotor and pull the con‐
necting cable plug out of the socket.
2
1
► Insert nuts (2) in the barrier bar (1) so that the
holes line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (5) and
barrier bar (4) on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert and tighten down the screws (8) firmly.
English
3
4
5
3 4
5
6
7
8
23