Balancing The Machine; Starting / Stopping The Engine - Stihl FS 410 C-M Notice D'emploi

English

Balancing the Machine

The unit is balanced differently
depending on the cutting attachment
used.
With the unit suspended from the
N
harness, see how it is balanced and
change attachment point as
necessary:
Floating Positions
Brush knives should just touch the
ground.
Circular saw blades should "hover"
about 20 cm above the ground.
22
Throwing Off Machine
WARNING
The machine must be quickly thrown off
in the event of imminent danger.
Practice removing and putting down the
power tool as you would in an
emergency. To avoid damage, do not
throw the power tool to the ground when
practicing.
Starting / Stopping the
Engine
Controls
3
2
1
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop
positions. Depress the stop switch
(...) to switch off the ignition.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position, i.e. when it is not depressed:
The ignition is switched on – the engine
is ready to start. Operate the stop switch
to switch off the ignition. The ignition is
switched on again automatically after
the engine stops.
FS 410 C-M, FS 460 C-M