Balancing The Trimmer; Fitting And Adjusting The Carrying System; Adjusting The Bike Handle - Stihl FSA 130 Notice D'emploi

English
► Push battery (4) as far as it will go into the belt
bag (5).
A short beep will sound.
► Secure battery (4) with the Velcro® fasten‐
ing (6).
7.3.2 Adjusting the Connecting Cable
The connecting cable can be fitted and adjusted
to suit the user's size and the application.
3
The length of the connecting cable can be adjus‐
ted by making a loop (1) and securing it to the
belt bag (3) with the fastener (2).
► Arrange the connecting cable so that it is as
short as possible without hindering your work.
7.3.3 Fitting and Adjusting the Carrying Sys‐
tem
► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the cara‐
biner (2) is about a hand's width below your
right hip.
7.4

Adjusting the Bike Handle

The bike handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter and pull the con‐
necting cable plug out of the socket.
► Hook the brushcutter from the carrying strip
into the carabiner of the carrying system.
36
2
1
1
2
7 Adjusting Trimmer for User
► Loosen the wing screw (1).
► Swing the bike handle (2) to the required posi‐
tion.
► Tighten down the wing screw (1) firmly.
7.5

Balancing the Trimmer

► Switch off the trimmer and pull the connecting
cable plug out of the socket.
1
2
► Hook the carrying strip (2) onto the carabi‐
ner (1).
► Let go of the trimmer and check to see how it
is balanced - the cutting attachment should
just rest on the ground.
► If the trimmer cannot be balanced: Change the
attachment point of the carabiner (1) on the
carrying strip (2) and check balance again.
2
1
0458-726-9621-C