Stihl Fsa 130 Trimmer - Stihl FSA 130 Notice D'emploi

18 Troubleshooting
18 Troubleshooting
18.1 Troubleshooting the Brushcutter and Battery
Fault LEDs on the
battery
The brushcutter 1 LED flashing
does not start green.
when switched
on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs
flash red.
The brushcutter 3 LEDs light
cuts out during up red.
operation.
The runtime of
the brushcutter is
too short.
19 Specifications
19.1

STIHL FSA 130 Trimmer

– Approved batteries:
0458-726-9621-C
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
The brushcutter has a
malfunction.
Trimmer is too hot.
There is a fault in the
battery.
No electrical contact
between brushcutter
and battery.
The brushcutter or
battery is damp.
Trimmer is too hot.
There is an electrical
fault.
The battery is not fully
charged.
The battery life has
been exceeded.
– STIHL AR
– STIHL AP together with "AP belt bag with
Remedy
► Recharge the battery fully as described
in the User Manual for the STIHL
AL 101, 301, 301-4, 500 chargers.
► Pull the connecting cable plug out of the
socket.
► Allow the battery to cool down or warm
up.
► Pull connecting cable plug out of the
socket and plug it in again.
► Switch on the brushcutter.
► If 3 LEDs continue to flash red: Do not
use your brushcutter and contact your
STIHL dealer for assistance.
► Pull the connecting cable plug out of the
socket.
► Allow trimmer to cool down.
► Pull connecting cable plug out of the
socket and plug it in again.
► Switch on the brushcutter.
► If 4 LEDs continue to flash red: Do not
use the battery; contact a STIHL authori‐
zed dealer.
► Pull connecting cable plug out of the
socket and plug it in again.
► If the brushcutter still does not start
when switched on: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's user manual or in
the user manual for the "AP belt bag with
connecting cable".
► Allow the brushcutter or battery to dry.
► Pull the connecting cable plug out of the
socket.
► Allow trimmer to cool down.
► Pull connecting cable plug out of the
socket and plug it in again.
► If the brushcutter continues to cut out
during operation: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's user manual or in
the user manual for the "AP belt bag with
connecting cable".
► Switch on the brushcutter.
► Recharge the battery fully as described
in the User Manual for the STIHL
AL 101, 301, 301-4, 500 chargers.
► Replace battery.
connecting cable"
English
41