Fitting The Full Harness; Balancing The Trimmer/Brushcutter; Starting / Stopping The Engine - Stihl FS 460 C-M K Notice D'emploi

English

Fitting the Full Harness

Fitting the full harness is described in
detail in the instruction sheet supplied.
1
2
3
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attach the spring hook to the
N
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
18
All manuals and user guides at all-guides.com
Balancing the
Trimmer/Brushcutter
With the unit suspended from the
N
harness, see how it is balanced and
change attachment point as
necessary:
Circular Saw Blades
Circular saw blades should "hover"
about 20 cm above the ground.
Throwing off the machine in an
emergency
The machine must be quickly thrown off
in the event of imminent danger.
Practice removing and putting down the
machine as you would in an emergency.
To avoid damage, do not throw the
machine to the ground when practicing.
Starting / Stopping the
Engine
Controls
3
2
1
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop
positions. Depress the stop switch
(...) to switch off the ignition.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position: Ignition is on in this position –
the engine is ready to start and may be
started. The ignition is switched off when
the stop switch is depressed. It is
automatically switched on again after
the engine comes to a standstill.
FS 460 C-M K