Fueling; Fitting The Harness - Stihl FS 70 Notice D'emploi

Masquer les pouces Voir aussi pour FS 70:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

Fueling

Preparations
Before fueling, clean the filler cap
N
and the area around it to ensure that
no dirt falls into the tank.
Position the machine so that the
N
filler cap is facing up.
Opening the Tank Cap
Turn the cap counterclockwise until
N
it can be removed from the tank
opening.
Remove the tank cap.
N
18
Filling Up with Fuel
Take care not to spill fuel while fueling
and do not overfill the tank.
STIHL recommends you use the STIHL
filler nozzle for fuel (special accessory).
Fill up with fuel.
N
Closing the Tank Cap
Place the cap in the opening.
N
Turn the cap clockwise as far as
N
stop and tighten it down as firmly as
possible by hand.

Fitting the Harness

The type and style of the harness
depend on the market.
The use of the harness is described in
the chapter on "Approved Combinations
of Cutting Attachment, Deflector, Handle
and Harness".
Shoulder Strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
1
FS 70 R

Publicité

Chapitres

Table des Matières
loading

Table des Matières