Mowing Heads - Stihl FS 70 Notice D'emploi

Masquer les pouces Voir aussi pour FS 70:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3
4
5
The nut (3), rider plate (4) and thrust
washer (5) are required to secure some

mowing heads.

These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Block the shaft.
2
8
7
The output shaft (2) must be blocked
with the stop pin (7) or screwdriver (7) to
mount or remove cutting tools. These
parts come standard with the machine or
are available as special accessories.
FS 70 R
Insert the stop pin (7) or offset
N
screwdriver (7) in the hole (8) in the
gearbox as far as stop – and apply
slight pressure.
Rotate shaft or cutting attachment
N
until the stop pin slips into position
and blocks the shaft.
Mounting the Cutting Attachment
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
7
1
Screw the mowing head
N
counterclockwise on to the shaft (1)
as far as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
Block the shaft.
N
Unscrew the mowing head
N
clockwise.
Mounting Metal Cutting Attachment
Keep the leaflet and packaging of the
metal cutting tool in a safe place.
English
15

Publicité

Chapitres

Table des Matières
loading

Table des Matières