Maintaining The Mowing Head - Stihl FSA 90 Notice D'emploi

Masquer les pouces Voir aussi pour FSA 90:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 75
English
Maintaining the Mowing
Head
Placing Power Tool on the Ground
Move the retaining latch to ƒ and
N
remove the battery.
Position your power tool so that the
N
cutting attachment mounting face is
pointing up.
Replacing Nylon Line
Always check the mowing head for signs
of wear before replacing the nylon line.
WARNING
If there are signs of serious wear,
replace the complete mowing head.
The nylon mowing line is referred to as
"nylon line" or "line" in the following.
62
The mowing head is supplied with
illustrated instructions for replacing the
nylon line. Keep the instructions for the
mowing head in a safe place.
If necessary, remove the mowing
N
head.
Adjusting Nylon Line
STIHL SuperCut
Fresh line is advanced automatically if
the remaining line is at least 6 cm
(2 1/2 in) long. The blade on the
deflector trims overlong lines to the
correct length.
STIHL AutoCut
With the engine running, hold the
N
rotating mowing head above the
grass surface.
Tap it on the ground once – fresh
N
line is advanced and the blade on
the deflector trims it to the right
length.
Fresh line is advanced every time the
mowing head is tapped on the ground.
For this reason observe the mowing
head's cutting performance during
operation. If the mowing head is tapped
on the ground too often, the line limiter
blade will unnecessarily cut off unused
lengths of nylon line.
Line feed operates only if both lines are
still at least 2.5 cm (1 in) long.
Replacing Nylon Line
STIHL PolyCut
Precut lengths of nylon line can be fitted
to the PolyCut in place of the cutting
blades.
STIHL DuroCut, STIHL PolyCut
WARNING
Before fitting fresh lines in the mowing
head, set the retaining latch to ƒ and
remove the battery – this helps reduce
the risk of injury.
Fit nylon line in the mowing head as
N
described in the instructions
supplied.
Replacing Cutting Blades
STIHL PolyCut
Always check the mowing head for signs
of wear before installing new cutting
blades.
WARNING
If there are signs of serious wear,
replace the complete mowing head.
The thermoplastic cutting blades are
referred to as "blades" in the following.
The mowing head is supplied with
illustrated instructions for replacing the
blades. Keep the instructions for the
mowing head in a safe place.
FSA 90, FSA 90 R

Publicité

Table des Matières
loading

Table des Matières