Stihl FSA 90 Notice D'emploi page 55

WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Mount only one metal cutting
attachment.
Check direction of rotation of cutting
attachment
1
2
The cutting edges of the grass cutting
blades (1) and (2) may point in either
direction – these cutting attachments
must be turned over regularly to reduce
one-sided wear.
Cutting edges of grass cutting blade (3)
must point clockwise.
WARNING
Direction of rotation is indicated by an
arrow on the inside of the deflector.
FSA 90, FSA 90 R
Place the cutting attachment (4) on
N
the fanwheel (5).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
3
Securing the cutting attachment
Fit the thrust washer (6) – convex
N
side must face up.
Fit the rider plate (7).
N
Block the shaft (8).
N
Screw the mounting nut (9) on to the
N
shaft counterclockwise and tighten
it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
Remove the tool used to block the shaft.
Removing the Metal Cutting Attachment
9
7
Wear protective gloves to reduce the
6
risk of direct contact with the sharp
4
cutting edges.
8
N
5
N
N
NOTICE
WARNING
Block the shaft.
Unscrew the mounting nut
clockwise.
Take the cutting attachment and its
mounting hardware off the
fanwheel (5) – but do not remove
the fanwheel.
English
53