Balancing The Machine - Stihl FSA 90 Notice D'emploi

English
Full Harness
2
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Balance the machine – see
N

"Balancing the Machine".

58
Balancing the Machine
The type and style of the harness and
carabiner (spring hook) depend on the
market.
Attaching Machine to Harness
1
1
2
Attach the carabiner (1) to the
N
carrying ring (2) on the shaft.
Floating Position
The cutting attachment should just
N
touch the ground.
The correct floating position is obtained
as follows:
Balancing the Machine
2
Loosen the screw (3).
N
Move the carrying ring (2) up or
N
1
down the shaft – tighten the screw
moderately – let the machine go and
wait until is its balanced – then
check the floating position.
When the correct floating position has
been reached:
Tighten down the screw on the
N
carrying ring firmly.
Detaching Machine from Harness
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
3
2
1
1
2
2
FSA 90, FSA 90 R