Led On Charger; Fitting The Harness - Stihl FSA 90 Notice D'emploi

LED on Charger

1
The LED (1) on the charger may glow
continuously green or flash red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "LEDs on battery".
The green LED on the charger goes off
as soon as the battery is fully charged.
Red flashing light ...
... may indicate the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"LEDs on Battery".
Malfunction in charger – have
–
checked by a servicing dealer.
STIHL recommends an authorized
STIHL servicing dealer.
FSA 90, FSA 90 R

Fitting the Harness

The type and style of the
harness/shoulder strap depend on the
market.
The use of the shoulder strap/harness is
described in the chapter on "Approved
Combinations of Cutting Attachment,
Deflector, Handle and Harness".
Use Type AR batteries only with the
harness provided – do not combine with
other carrying straps (e.g. shoulder
strap, full harness, etc.).
Shoulder Strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Balance the machine – see
N
"Balancing the Machine".
English
1
57