Led On Charger; Removing And Fitting The Battery; Fitting The Battery; Removing The Battery - Stihl HSA 56 Notice D'emploi

7 Removing and Fitting the Battery

6.2.2 State of Charge
1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery,
@ 6.1.
6.3

LED on Charger

The LED indicates the operating status of the charger. LED
glows green or flashes red.
LED glows green and LEDs on battery glow or
flash green. Battery is being charged.
LED flashes red. No electrical contact between
battery and charger or malfunction in battery or
charger.
If the LED glows green and 1 LED on the battery glows red:
Battery is too hot or too cold.
► Troubleshooting, @ 16.1.
HSA 56
7
80-100%
60-80%
7.1
40-60%
20-40%
1
0-20%
2
► Insert the battery (1) in the battery compartment and press
it home until it engages with an audible click.
Arrows (3) on battery (1) are still visible and battery (1) is
held securely in battery compartment (2). There is no
electrical contact between the hedge trimmer and battery
(1).
► Push the battery (1) into the battery compartment (2) as far
as stop.
The battery (1) engages with a second click and is flush
with the hedge trimmer's housing. Your hedge trimmer is
ready for operation.
7.2
► Stand the hedge trimmer on a level surface.
Removing and Fitting the Battery

Fitting the Battery

Removing the Battery

English
3
41