Fitting The Full Harness; Balancing The Trimmer/Brushcutter - Stihl FS 510 C-M Notice D'emploi

English
Opening screw-type tank cap
Turn the cap counterclockwise until
N
it can be removed from the tank
opening.
Remove the cap.
N
Filling up with fuel
Take care not to spill fuel while fueling
and do not overfill the tank.
STIHL recommends you use the STIHL
filler nozzle for fuel (special accessory).
Filling up with fuel
N
Closing screw-type tank cap
Place the cap in the opening.
N
Turn the cap clockwise as far as
N
stop and tighten it down as firmly as
possible by hand.
28

Fitting the Full Harness

Fitting the full harness is described in
detail in the instruction sheet supplied.
2
3
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attach the spring hook to the
N
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
Balancing the
Trimmer/Brushcutter
The machine will balance differently
depending on the cutting attachment
mounted.
Let the machine swing on the
N
harness until it stops moving –
1
change the connection point if
necessary
Hanging positions
Mowing heads, grass cutting blades,
brush knives and shredder blades
should rest lightly on the ground.
Circular saw blades should "hover"
approx. 20 cm above the ground.
FS 510 C-M, FS 560 C-M