Mounting The Cutting Attachment - Stihl FS 510 C-M Notice D'emploi

chapters "Mounting the Cutting
Attachment" / "Mounting the Mowing
Head" / "Mounting Grass Cutting
Blades".
6
1
Place the guard washer (6) on the
N
thrust washer – the whole collar
(arrows) on the shaft (1) must be
visible.
FS 510 C-M, FS 560 C-M
Mounting the Cutting
Attachment
Mounting Hardware for Cutting
Attachment
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
The appropriate deflectors and
mounting hardware are available as
special accessories for subsequently
equipping the machine with different
cutting attachments – see chapter on
"Special Accessories".
Always use and assemble the cutting
attachment mounting hardware as
described in the chapter on "Mounting
the Cutting Attachment".
Thrust plate
A
60-mm diameter (A) version for
–
mowing heads ands grass cutting
blades.
65-mm diameter (A) version for
–
brush knives, shredder blades and
circular saw blades.
The thrust plate is necessary for
mounting all cutting attachments to the
gearbox.
Thrust washers
A
60-mm diameter (A) version for
–
grass cutting blades and circular
saw blades.
70-mm diameter (A) version for
–
brush knives and shredder blades.
Rider plates, guard ring and nut
Approximately 80-mm diameter (A)
A
–
rider plate (1) for grass cutting
blades.
Approximately 63-mm diameter (A)
–
rider plate (2) for circular saw
blades.
English
A
A A
21