Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
6
5
4
b
a
Place the cutting attachment (3) in
N
position.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Fit the 60-mm diameter thrust
N
washer (4) – convex side must face
up.
Fit the 80-mm diameter rider plate
N
(5).
Block the drive shaft.
N
Screw on the nut (6)
N
counterclockwise and tighten it
down firmly.
24
Removing the cutting attachment
Block the drive shaft.
N
Unscrew the mounting nut (6)
N
clockwise.
Pull the cutting attachment with its
N
3
mounting hardware off the gearbox.
Mounting Brush Knives
Check that the deflector on the
N
machine is approved for brush
knives – if not, perform the next two
steps.
Remove grass shield with thrust
N
plate – if fitted.
Remove the non-approved
N
deflector.
Mount deflector for grass cutting
N
blades and brush knives.
Use the 65-mm diameter thrust
N
plate.
1
Brush knives 305-2 (1) and 350-3 (2)
may point in either direction – these
cutting attachments must be turned over
regularly to help avoid one-sided wear.
Place the cutting attachment (3) in
N
position.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Fit the 70-mm diameter thrust
N
2
washer (4) – convex side must face
up.
Fit the guard ring (5) for brush
N
knives – opening must face up.
Block the drive shaft.
N
Screw on the nut (6)
N
counterclockwise and tighten it
down firmly.
6
5
3
4
3
b
a
FS 510 C-M, FS 560 C-M
Publicité
Chapitres
Table des Matières
