Stihl FS 510 C-M Notice D'emploi page 21

4
5
3
1
Position the lower clamp (1) against
N
the underside of the drive tube next
to the gearbox.
Position the upper clamp (4) on the
N
drive tube so that the lug (5)
engages the notch (3).
Hold both clamps steady in this
N
position.
Insert a screw into the hole marked
N
1 on the upper clamp (4) and wind it
only a few turns into the lower clamp
(1).
Insert a screw in each of the holes
N
marked 2, 3 and 4 and wind them
only a few turns into the lower
clamp.
FS 510 C-M, FS 560 C-M
Slide the clamps up against the
N
gearbox and engage the lug (5) in
the gearbox gap (arrows).
Hold both clamps in this position.
N
Screw home the screws in holes 1
N
and 2 as far as stop.
Tighten down the screws in holes 1
N
and 2 to a torque of 8 Nm.
Screw home the screws in holes 3
N
and 4 in that order and tighten them
down to a torque of 8 Nm.
– Mounting the shredder deflector
6
Position the shredder deflector on
N
the lower clamp with its concave
side facing the gearbox (6).
Insert the screws (7) and tighten
N
them down firmly.
– Plugs
9
6
8
Plugs (9) are available as special
accessories to help prevent dirt getting
into the unused tapped holes for the
deflector in the gearbox (6) and clamps
(8).
English
19