Stihl FS 510 C-M Notice D'emploi page 27

Removing the cutting attachment
Block the drive shaft.
N
Unscrew the mounting nut
N
clockwise.
Pull the cutting attachment with its
N
mounting hardware off the gearbox.
Mounting shredder blade 320-2
Check that the deflector on the
N
machine is approved for shredder
blades – if not, perform the next two
steps.
Remove grass shield with thrust
N
plate – if fitted.
Remove the non-approved
N
deflector.
Mount deflector for shredder blade.
N
Use the 65-mm diameter thrust
N
plate.
Seal the unused tapped holes with
N
plugs.
FS 510 C-M, FS 560 C-M
4
3
2
b
a
Place the shredder blade (1) in
N
position – cutting edges must point
clockwise and the vertical ends of
the blade must face up.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
The cutting edges of the shredder blade
(1) must point upwards.
Fit the 70-mm diameter thrust
N
washer (2) – convex side must face
up.
Fit the shredder blade guard ring (3)
N
– opening must face up.
Block the drive shaft.
N
Screw on the nut (4)
N
counterclockwise and tighten it
down firmly.
Removing the cutting attachment
Block the drive shaft.
N
Unscrew the mounting nut
N
clockwise.
Pull the cutting attachment with its
N
1
mounting hardware off the gearbox.
If you intend to use a different
N
cutting attachment – remove the
shredder deflector.
Mounting circular saw blades 225
Check that the stop for circular saw
N
blades is already mounted to the
machine – if not, perform the next
two steps.
Remove grass shield – if fitted.
N
Remove deflector – if fitted.
N
Mount limit stop for circular saw
N
blades.
Use the 65-mm diameter thrust
N
plate.
Seal the unused tapped holes with
N
plugs.
The cutting edges of circular saw blades
must point clockwise.
English
25