Stihl FS 460 C-M K Notice D'emploi page 28

English
Releasing Tension on Rewind Spring
Use the tensioning wrench. It is
N
available as a special accessory.
3
2
2
5
If necessary, swing the pawls (2)
N
inwards.
Rotate the spring clip (3) out of the
N
recesses (4) in the carrier (5).
4
Place the tensioning wrench in the
N
carrier so that the peg (6) engages
one of the recesses (4).
26
All manuals and user guides at all-guides.com
Use starter grip to pull out the starter
N
rope as far as stop.
Hold the tensioning wrench and the
N
starter mechanism steady so that
the rope does not rewind onto the
rope rotor.
Grip the rope inside the housing,
N
pull it out to its full length and make
a loop.
Allow tensioning wrench to rotate
N
slowly and thus release spring
tension – the rope winds itself
6
around the tensioning wrench in this
process until the spring is no longer
under tension.
Remove the tensioning wrench from
N
the carrier.
Removing the Rope Rotor
7
3
Use a screwdriver or suitable pliers
N
to remove the spring clip (3) from
the starter post.
Carefully remove the E-clip (7).
N
9
Carefully remove the carrier (5) with
N
pawls (2) and washer (8) and put
them to one side so that the pawls
and washer cannot fall out.
Pull the rope rotor (9) off the starter
N
post.
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
FS 460 C-M K
5
2
8