Stihl FS 460 C-M K Notice D'emploi page 13

9
10
Use the spring (9) from the parts kit
N
supplied with the machine.
Place the spring (9) in the lower
N
clamp molding (10).
A
1
2
11
Position the clamp moldings (1) with
N
handlebar (2) on the handle
support (11).
FS 460 C-M K
All manuals and user guides at all-guides.com
7
2
Raise the grip of the wing screw (7)
N
to the upright position.
Turn the wing screw
N
counterclockwise as far as stop.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Adjust the handlebar (2) so that
N
distance A is no more than 15 cm.
Line up the handlebar at a right
N
angle to the drive tube.
Turn the wing screw clockwise as
N
far as stop.
Fold the grip of the wing screw down
N
so that it is flush.
Adjusting the handlebar
Opening the wing screw
Raise the grip of the wing screw to
N
the upright position.
Turn the wing screw
N
counterclockwise until the handle
support can be moved.
English
11