Engine Running Behavior; Replacing The Starter Rope And Rewind Spring - Stihl FS 460 C-M K Notice D'emploi

Installing the Spark Plug
Screw the spark plug into the
N
cylinder.
Press the spark plug boot firmly
N
onto the spark plug.
4
3
2
Fit the cap (1) on the shroud from
N
the rear and push the lug (2) into the
opening (3) in the shroud at the
same time.
Swing the cap forwards onto the
N
shroud, insert and tighten down the
screw (4) firmly.
FS 460 C-M K
All manuals and user guides at all-guides.com

Engine Running Behavior

If engine running behavior is still
unsatisfactory after servicing the air filter
and adjusting the throttle cable, the
cause may be the muffler.
Have the muffler checked by a servicing
dealer for contamination
(carbonization).
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
Replacing the Starter Rope
and Rewind Spring
Removing the Rewind Starter
1
1 1
Take out the screws (1).
N
Lift away the rewind starter.
N
Replacing the Starter Rope and Rewind
Spring
If either the starter rope or rewind
N
spring is broken, continue with
"Removing the Rope Rotor".
If either the starter rope or rewind
N
spring are being replaced as a
precautionary measure, continue
with the following chapter.
English
1
25