Adjusting The Throttle Cable - Stihl FS 500 Notice D'emploi

English
5
1
5
1
N Place the handlebar (5) in the lower
clamp (1) so that distance A is no
more than 15 cm.
N Place the upper clamp in position
and press it down.
N Fit the clamp screws and hex head
screw.
N Line up the handlebar at a right
angle to the drive tube.
N Tighten down the clamp screws
first, then the hex head screw.
14
A
7
A
N
Take out the screw (6) and remove
it with the washer.
N Push the control handle (7) onto the
end of the handlebar (8) until the
holes (9) line up – the throttle trigger
must point towards the gearhead.
N Insert the screw (with washer) and
tighten it down firmly.
Transport and storage position: Loosen
the clamp screws and hex head screw,
turn the handlebar in line with the drive
tube and fold the handles down.
7
6
8
9
Adjusting the Throttle
Cable
Some machine versions are equipped
with a throttle cable adjuster on the
control handle.
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
Adjust the throttle cable only after the
unit is fully assembled – the control
handle must be in the normal operating
position.
N Use a suitable tool to push the slide
to the end of the slot (see
illustration).
2
N
Press down the throttle trigger
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
FS 500, FS 550
1