Spark Arresting Screen In Muffler; Spark Plug - Stihl FS 90 Notice D'emploi

Spark Arresting Screen in
Muffler
The muffler is equipped with a spark
arresting screen.
If the engine is down on power,
N
check the spark arresting screen in
the muffler.
Wait for the muffler to cool down.
N
Move the slide control to STOP-0.
N
Take out the screw (1).
N
3
2
Take out the screws (2) and remove
N
the shroud (3).
FS 90, FS 90 R
Take out the screw (4).
N
Lift the spark arresting screen (5)
N
and pull it out.
Clean the spark arresting screen. If
N
the screen is damaged or heavily
1
carbonized, fit a new one.
Refit the spark arresting screen.
N
Insert screw and tighten it down
N
firmly.
Install the shroud.
N
2

Spark Plug

If the engine is down on power,
N
difficult to start or runs poorly at idle
speed, first check the spark plug.
Fit a new spark plug after about 100
N
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the spark plug
Move the slide control to STOP-0.
N
1
Pull off the spark plug boot (1).
N
Unscrew the spark plug.
N
English
31